|
SPRAY ANGLE OPTIONS FOR JET NOSE NOZZLES
|
|
|
Rear jet angle are possible ranging from 35 degrees to 60 degrees in the groove. It’s possible to drill 90 degree side jets in the knurled area in the nose section. Forward jets can be drilled from 0 degrees (straight ahead) up to 45 degrees.
|
|
SPRAY ANGLE OPTIONS FOR ROTARY JET NOZZLES
|
|
|
The Rotor Jet (RJ) nozzle can accommodate spray angle ranging from 90 degrees for most side wall impact, to thrust angles down to 40 degrees on the 1/4” & 3/8” NPT sizes and 30 degrees on the 1/2” NPT size. Two jets (with one spray angle), or four jets (with two spray angles) are possible.
|
|
SPRAY ANGLE OPTIONS FOR BUTTON NOSE NOZZLES
|
|
|
Rear jet angle are possible ranging from 25 degrees to 35 degrees on the rear groove, and 35 degrees to 55 degrees on the forward groove. It’s possible to drill 90 degree side jets in the knurled area to the left of the forward groove. Forward jets can be drilled from 0 degrees (straight ahead) up to 45 degrees.
|
|
45 DEGREE RAM (on Jet Nose body)
|
|
|
This pattern has 45° thrust angles for strong pulling and flushing power. And a single forward jet to cut through blockages.
|
|
45 DEGREE OFFSET (on Jet Nose body)
|
|
|
This pattern has 45° thrust angles for strong pulling and flushing power. And an single offset forward jet to cut through side wall debris.
|
|
DE-ICER (on Jet Nose body)
|
|
|
This pattern has 45° thrust angles for strong pulling and flushing power. And an three 10 degree offset forward jets to clean side wall debris. This pattern is also useful for applications where it’s helpful to push debris forward.
|
|
SIDE WALL CLEANER (on Rotary Jet)
|
|
|
The 90 degree side jets deliver the most impact for side wall cleaning. This would be a two jet pattern. |
|
SIDE WALL FLUSHER (on Rotary Jet)
|
|
|
The 60 degree side jets delivers good side wall cleaning and flushing action with a small amount of thrusting / pulling power. This would be a two jet pattern. |
